LDM899TP combo sensor.   Perfect for converter pressure/temp.  outputs 0.5V to 4.5V signal for PSI.  0 to 300 psi  and 0-500*F in one sensor! 1/8" NPT 8.5 feet flying lead.  (Enough extra wire to cut and add connector...

0-200 PSI 5V pressure sensor 0.5V to 4.5V Heavy duty Stainless steel body 1/8" NPT thread Includes GT150 packard connector, pins, and grommets. (Pre-wired cable sold separately) Compatible with all EFI and data logging systems.  Typical uses;...

0-100 PSI pressure sensor 0.5V to 4.5V Heavy duty Stainless steel body 1/8" NPT thread Includes GT150 packard connector, pins, and grommets. (Pre-wired cable sold separately) Compatible with all EFI and data logging systems.  Typical uses; dome...

USB 3.0 bulkhead connector  12" long cable with female Requires 1" hole Bulkhead is IP67 rated (waterproof) Includes 6' 6" long, USB 3.0 programming cable to be used between Bulkhead and laptop. Prefect for mounting in dash. Can also be used on...

Fits all Lowdoller pressure sensors and map sensors. *Roughly 15' ft long cable Includes GT150 3 pin connector and RB290 boot.

Kit includes everything needed to install. All Brass Intake Air Temp Sensor M16 X 1.5 thread M16 X 1.5 billet aluminum weld bung New electrical connector  2 crimp pins 2 silicone grommet seals Temp (°F) Resistance value (Ohms) 284 36.17 ...

Looking for an affordable replacement driveshaft speed sensor? Tired of setting gaps only to find it still isn’t reading properly?   Well, here’s the solution!  built in LED indicator light for setup Triggered by ferrous material...

Take control of your LS engine with Terminator X! Don't settle for a junkyard ECU with a cumbersome tuning interface when you can have complete control of your engine, self-learning fuel strategies and the proven, race-winning technology of Holley EFI at...

NEW! FC1 Seat • Constructed from Grade 5052 Aluminum • Innovative 2 piece design makes assembly simple. Hardware to assemble included. • Sizes 14"-18" in 1" increments • 10º or 20º Layback • Standard Shoulder Belt...

NEW! FC1 Seat • Constructed from Grade 5052 Aluminum • Innovative 2 piece design makes assembly simple. Hardware to assemble included. • Sizes 14"-18" in 1" increments • 10º or 20º Layback • Standard Shoulder Belt...

NEW! FC1 Seat • Constructed from Grade 5052 Aluminum • Innovative 2 piece design makes assembly simple. Hardware to assemble included. • Sizes 14"-18" in 1" increments • 10º or 20º Layback • Standard Shoulder Belt...

V-Band Clamp Assembly, 4 in OD Tubing, O-Ringed, Aluminum, Natural, Each