Fuel Injection

0-300 PSI 5V pressure sensor 0.5V to 4.5V Heavy duty Stainless steel body 1/8" NPT thread Includes GT150 packard connector, pins, and grommets. (Pre-wired cable sold separately) Compatible with all EFI and data logging systems.  Typical uses;...

Exhaust Gas Temperature is a critical indicator of the performance of a typical racing engine.

0-100 PSI pressure sensor 0.5V to 4.5V Heavy duty Stainless steel body 1/8" NPT thread Includes GT150 packard connector, pins, and grommets. (Pre-wired cable sold separately) Compatible with all EFI and data logging systems.  Typical uses; dome...

Fits all Lowdoller pressure sensors and map sensors. *Roughly 15' ft long cable Includes GT150 3 pin connector and RB290 boot.

0-200 PSI 5V pressure sensor 0.5V to 4.5V Heavy duty Stainless steel body 1/8" NPT thread Includes GT150 packard connector, pins, and grommets. (Pre-wired cable sold separately) Compatible with all EFI and data logging systems.  Typical uses;...

LDM899TP combo sensor.   Perfect for converter pressure/temp.  outputs 0.5V to 4.5V signal for PSI.  0 to 300 psi  and 0-500*F in one sensor! 1/8" NPT 8.5 feet flying lead.  (Enough extra wire to cut and add connector...

4 bar map sensor. (-1 bar to +3bar) -14.7 PSI to + 43.5 PSI Absolute pressure sensor -14.7 PSI = 0.5 Volts,   0 PSI = 1.46 Volts, 43.5 PSI = 4.5 Volts Outputs 0.5V to 4.5V Input 5V Accuracy 0.5% of full scale.  Heavy duty Stainless steel...

5/16"-24 hall effect speed sensor.   Triggered by magnets (Not ferrous material) 5/16"x24 body Built in LED light for easy setup Nickel plated Detection range 0.1MM to 10MM Flush mount Supply voltage 10V-30V Short circuited/reverse protection built...

5/16"-24 hall effect speed sensor.   Triggered by ferrous material (Not magnets) 5/16"x24 body Built in LED light for easy setup Stainless steel body Detection range 0.1MM to 1MM (0.004" to 0.04") Flush mount Supply voltage 10V-30V Short...

AEM's X-Series OBDII Wideband UEGO AFR Sensor Controller Gauge (PN 30-0334) provides tuners who are using piggyback tuning modules or open source software with the ability to view AFR through the factory CAN-bus stream that is output by the factory ECU,...

Oil filled Silicon 899 series.  Specifically designed for DOME PRESSURE  / boost controllers  and other applications that require the cleanest data possible.    0-100 PSI pressure sensor 0.5V to 4.5V Heavy duty Stainless steel...

This cast EFI intake elbow allows the use of GM LS throttle bodies on any intake manifold w/ the 4150 mounting flange. Slotted mounting holes & dual throttle cable mounting bracket bosses allow the elbow & throttle body to be mounted forward,...