Tools and Equipment

Walker Pit Tuning Filter. Forget worrying about getting dirt in the engine while tuning your carb with the air filter off! 6.25" Diameter 3.25" Tall Fits Holley style 4150 and 2bbl carbs.

Aluminum Coil Over Wrench  Available for 2.5" and 5" spring cups

Set your axle on and roll to check straightness. We also have a slot on the bottom to mark a straight line on new axles with a sharpie to keep an eye on axle twist.

Our Troy Brand inspired T-handle style axle puller removes your axle with ease acting as a slide hammer for tight or bent axles. Fits standard axles with 3/8" fine or coarse thread, and gun-drilled axles.

Install/remove your cage bearings with ease with our all new bearing tool! Use a hammer to tap the handle while the tool does the work. Comes with handle, punch, and ring.

Our NEW Shawn Kelly inspired Superlite brake pad sander makes it easy to bring life back to your Superlite style brake pads. With built in magnets in the pad sanders base, your brake pad will stay held in place while you sand...

Tool marks hole spacing 1"-6" with both a hole and a point. Edge spacing of 1/4" and 1/2". Comes with a 1"-4" mini version for hard to reach areas.

Our Jason Sivils inspired Ultra Force load rating machines are built with CNC machined components giving our machines unsurpassed strength and quality.  Our machine has the ability to smash a spring/bump stop setup to 4500# and pull a pull bar...

This is our suspension component measuring plate. Utilizing our heim center finder base design, we have made a sturdy 2-1/2'' wide plate with the center to center distance machine on it for quick reference. The plate fits 1/2'',...

Wheel Cover Holder, Wall Mount, 3-1/2 in Deep, 15 in Wheel Covers, Aluminum, White Powder Coat, Each

Our NEW Wireless Suspension Load Stick bolts in where your shock goes on a shock separate suspension, allowing you to change springs with ease and accuracy. The load stick is able to pull the race car down to dynamic attitude to find a suspension bind...

CNC machined structure weighing just 62 lbs. with a 4,000 lb. lifting capacity• Dual-action, 12V 3200 PSI hydraulic pump with quick disconnect couplers and cylinders that work with power up/power down...