Wehr Machine Racing Products

For those hard to reach areas, the stubby 1-1/16" wrench will do the trick. The wrench is 6" long.

Steel shock mount 1-1/2 or 1-1/4 tube, 3-3/4'' below center line. Use to mount shocks, 6th coil, & 5th coil setups to round tube.

Steel shock mount 1-1/2'' or 1-1/4" tube, 2-1/4'' below center line. Use to mount shocks, 6th coil, & 5th coil setups to round tube.

Our all-new Eco Smasher is a cost-effective way to smash your spring assembly. Its frame design was created to allow you to use your ratcheting suspension load stick as a spring smasher.  The...

Our 1" thick aluminum wheel spacer works with any wide-5 wheels except the Volkswagen wide-5 pattern.Comes with 5/8"-11 screw-in studs.

Our all new Quick Adjust Foam Limiter will make length adjustment easy and fast with our Quick Pin design.  This is a complete limiter with our 2" diameter 1" tall BLUE foam puck...

Our swivel cups will keep your springs happy when traveling by allowing rotation and angular alignment. These cups work with our hollow screw jacks or you can run on a stud on your axle in the rear...

Our new Receiver Pro flat mount uses 1/8" rivets to mount to a flat surface or your helmet to safely mount your Receiver out of the way.Receiver Pro NOT included.

Our aluminum clamp on 1/2'' heim mounts can mount any 1/2'' heim to a 1-1/4, 1-1/2, or 1-3/4'' tube. Designed to get the heim as close to the tube as possible. It works well on suspension limiters...

Our ride height set up sticks allow you to set your suspension at ride height or compression height to setup your front suspension with our WM316-5X5 setup plates. These are also used with our...

Steel clamp on 3/4'' heim mount 1-1/2'' round tube 5/8'' bolt.

Sleeve style pull bar pucks, 3/4 thick 70, 80 and 90 durometer, 2-1-8'' OD. Sold Each.