Wehr Machine Racing Products

Our all new Quick Adjust Foam Limiter will make length adjustment easy and fast with our Quick Pin design.  This is a complete limiter with our 2" diameter 1" tall BLUE foam puck...

Our swivel cups will keep your springs happy when traveling by allowing rotation and angular alignment. These cups work with our hollow screw jacks or you can run on a stud on your axle in the rear...

Our new Receiver Pro flat mount uses 1/8" rivets to mount to a flat surface or your helmet to safely mount your Receiver out of the way.Receiver Pro NOT included.

Our aluminum clamp on 1/2'' heim mounts can mount any 1/2'' heim to a 1-1/4, 1-1/2, or 1-3/4'' tube. Designed to get the heim as close to the tube as possible. It works well on suspension limiters...

Our ride height set up sticks allow you to set your suspension at ride height or compression height to setup your front suspension with our WM316-5X5 setup plates. These are also used with our...

Steel clamp on 3/4'' heim mount 1-1/2'' round tube 5/8'' bolt.

Sleeve style pull bar pucks, 3/4 thick 70, 80 and 90 durometer, 2-1-8'' OD. Sold Each.

This is the replacement tube ONLY for our RF tie rod with a LH stock inner. Tube is made like our 5/8" suspension tubes with 13/16" hex on each end. Approximately 15" long and is lasered with...

This is our complete RF tubular tie rod with LH rod end inner (18-3/4" - 20"). Tube has a 13/16" hex on each end like our 5/8" suspension tubes. Tie rod assembly comes with greasable heims with...

teel clamp-on pull bar bracket for 1-1/2" square tube. Holes are on an arc to keep pinion angle right when adjusting.Comes with 5/8" bolt and spacers to reduce 3/4" heim to bolt.

1/2"-20 thread 20" long strut tube to support lift bar.Comes with LH and RH 1/2" heim.

Clamps to 3'' rear end tube to run support strut to the lift bar for lateral support.