Wehr Machine Racing Products

This load stick bolts in where your shock goes on a shock separate suspension. The stick allows you to change springs with ease and accuracy, along with being able to pull the race car down to...

This new David Stremme inspired spring cup raises the spring up to enable you to run the RR shock bulb up and have trailing arm clearance. The cup raises the spring up 3". This cup has a 1/2" hole...

Our new Brad Waits designed quick change limit chain adjuster allows you to change your chain length by simply pulling a pin, moving to the next hole and inserting the pin. You can make a chain...

This new Travis Roth tool lets you instantly know after you crash if you need to change your spindle. Screws on your 1/2" fine thread upper ball joint and plunger points to center of lower...

These are a cross between a bolt and a shock pin. Don't trust the pin? These use a nut, like a bolt would. Spacer part is machined on like the pins, thread is 1/2'' -13 coarse. 2-1/8'' short steel...

This is our new long steel shock bolt with points. Same design as our WM148SL bolt, but we added a point at centerline on each end to easily measure center to center on your shock! Bolt is...

Our shock mount screw jack has a narrow steel shock mount welded to a 9'' screw jack. This is our 1'' coarse thread and comes with WM148SS shock bolt.

Steel Shock mount extension bolts into your existing mount on your chassis and extends the shock 2''. Comes with WM148SS shock bolt.

1"-8 coarse thread screw jack with slic pin tip

Our new limiter cans are a threaded sleeve style to easily adjust chain length with 2" of overall adjustment. Can will fit up to 3" tall and 2-1/4" OD bump stop or spring. This part number is our...

A little piece of mind with our jams. Lightweight aluminum instead of a heavy hex nut. They come in 1'' coarse, uses a 1-1/8'' wrench, and comes as a set of 4.