Wehr Machine Racing Products

1"-8 coarse thread screw jack with slic pin tip

Our new limiter cans are a threaded sleeve style to easily adjust chain length with 2" of overall adjustment. Can will fit up to 3" tall and 2-1/4" OD bump stop or spring. This part number is our...

A little piece of mind with our jams. Lightweight aluminum instead of a heavy hex nut. They come in 1'' coarse, uses a 1-1/8'' wrench, and comes as a set of 4.

Billet grand national hub socket with 1/2'' drive.

This is our Left Front tie rod with a short LH stock inner. This assembly uses our thick wall DOM machined suspension tube with a 13/16" hex on each end. The heim has a zerk for easy lubrication and...

This is our complete RF tubular tie rod with a short LH stock inner. Tube has a 13/16" hex on each end like our 5/8" suspension tubes. Tie rod assembly comes with greasable heim with dust...

Our Troy Brand inspired T-handle style axle puller removes your axle with ease acting as a slide hammer for tight or bent axles. Fits standard axles with 3/8" fine or coarse thread, and gun-drilled...

WEHRS MACHINE HIGH MIS-ALIGNMENT SPACERS 1/2" INSIDE DIAMETER 5/8" OUTSIDE DIAMETER (ROD END SIDE)

These slick mounts let you change the length of your panhard bar with ease. Change the length 2-9/16'' by simply swapping bars out.This mount fits 1-1/2'' x 1-1/2'' square tube. This part number is...

Chevelle lower control arm bushings are lightweight and greaseable for smooth travel. 

Chevelle lower control arm bushings are lightweight and greaseable for smooth travel. 

Just like our aluminum one, only made out of steel dom tubing, has two inches of adjustment like the aluminum one - just a little heavier. This bar is our body #1 with a WM40A and is 18''-20''.