Steel clamp on 3/4'' heim mount 1-1/2'' round tube 5/8'' bolt.

Sleeve style pull bar pucks, 3/4 thick 70, 80 and 90 durometer, 2-1-8'' OD. Sold Each.

This is the replacement tube ONLY for our RF tie rod with a LH stock inner. Tube is made like our 5/8" suspension tubes with 13/16" hex on each end. Approximately 15" long and is lasered with thread direction.Replacement tube only.

This is our complete RF tubular tie rod with LH rod end inner (18-3/4" - 20"). Tube has a 13/16" hex on each end like our 5/8" suspension tubes. Tie rod assembly comes with greasable heims with dust caps.

teel clamp-on pull bar bracket for 1-1/2" square tube. Holes are on an arc to keep pinion angle right when adjusting.Comes with 5/8" bolt and spacers to reduce 3/4" heim to bolt.

1/2"-20 thread 20" long strut tube to support lift bar.Comes with LH and RH 1/2" heim.

Clamps to 3'' rear end tube to run support strut to the lift bar for lateral support.

Our climber gear works on all Wehrs frame mounts and pinion mounts.

Fits any wide 5 hub except Volkswagen wide 5 pattern. Fine tune your track width to the max.

Our rear end drain pan makes changing gears a dream. It is wider to catch all the fluid, has a spot for each gear to drain, a spot to stand the rear cover up to drain, a spot for your rear cover nuts, and even your wrench. This...

Full synthetic, triple ester 2-stroke engine oil designed to ensure optimum protection and performance under extreme race conditions. Clean burning, ring stick resistant formulation utilizes high molecular weight, surface active esters to ensure optimal...

Transmission Mounting Bracket, 1/8″ Steel, 1″ X 7/16″ Slots