Wehrs Machine and Racing Products

Our NEW Dennis Schoenfeld inspired steel bearing chain mount allows you to mount a chain with a high mis-alignment heim to your axle tube to eliminate any chain bind.  Fits 3" axle tubes...

Our NEW Shawn Kelly inspired Superlite brake pad sander makes it easy to bring life back to your Superlite style brake pads. With built in magnets in the pad sanders base, your...

Our all-new Threaded Double Adjustable Limiter will make length adjustment easy and fast with our LH and RH adjust to allow for quick fine tuning of you suspension limiter.  This takes our 2"...

NEW fabricated RF chevelle lower for the USRA B-mod has a spring helix and uses a standard large Chrysler screw-in ball joint (not included). This lower comes with a WM200-8 bolt-on shock...

For those hard to reach areas, the stubby 1-1/16" wrench will do the trick. The wrench is 6" long.

Steel shock mount 1-1/2 or 1-1/4 tube, 3-3/4'' below center line. Use to mount shocks, 6th coil, & 5th coil setups to round tube.

Steel shock mount 1-1/2'' or 1-1/4" tube, 2-1/4'' below center line. Use to mount shocks, 6th coil, & 5th coil setups to round tube.

Our all-new Eco Smasher is a cost-effective way to smash your spring assembly. Its frame design was created to allow you to use your ratcheting suspension load stick as a spring smasher.  The...

Our 1" thick aluminum wheel spacer works with any wide-5 wheels except the Volkswagen wide-5 pattern.Comes with 5/8"-11 screw-in studs.

Our all new Quick Adjust Foam Limiter will make length adjustment easy and fast with our Quick Pin design.  This is a complete limiter with our 2" diameter 1" tall BLUE foam puck...

Our swivel cups will keep your springs happy when traveling by allowing rotation and angular alignment. These cups work with our hollow screw jacks or you can run on a stud on your axle in the rear...

Our new Receiver Pro flat mount uses 1/8" rivets to mount to a flat surface or your helmet to safely mount your Receiver out of the way.Receiver Pro NOT included.