Wehrs Machine and Racing Products

Chevelle lower control arm bushings are lightweight and greaseable for smooth travel. 

Just like our aluminum one, only made out of steel dom tubing, has two inches of adjustment like the aluminum one - just a little heavier. This bar is our body #1 with a WM40A and is 18''-20''.

3/4"-16 RH and LH double adjuster with 2-1/2" of thread in each direction. 6-1/2" overall length.

Lightweight 1/2'' -20 fine thread hood pin with the flange machined on them for the hood to sit on so you don't have to put a rubber hose on the pin. 4'' long from flange to bottom of threads.

This clamps to a 1-1/4" lower tube to fasten your limit chain to.

Inner Tie Rod Stud

Mounts metric caliper to the front side of the Pinto spindle. NOT IMCA LEGAL! Only works with hybrid rotors.

Our re-designed limit chain axle clamp has a 3/8" clevis welded to a 1" wide clamp for increased strength.

Our new swivel cups will keep your springs happy during travel by allowing rotation and angular alignment. They work with our hollow screw jacks or you can run them on a stud on the rear end...