Rear Suspension

This tool helps you set your radius rod lengths to the exact measurement you need. 

Billet aluminum rear end limiter bracket Fits all 3″ axle tubes. NOTE: Chain and bolts sold separately

Replacement shaft for WM251 24" extended slider. Overall length is 12-3/4" and shaft portion is 9-3/4".

Mount kit includes (1) top and (1) bottom shock travel sensor bracket. Powder coated in gloss black. Mounts 1 sensor. 

Our shock mount screw jack has a narrow steel shock mount welded to a 9'' screw jack. This is our 1'' coarse thread and comes with WM148SS shock bolt.

Steel shock swivel to eliminate binding. The swivel is sold separately WM200-8

Zinc Plated Steel Spacer Bushings, 3/4″ OD, 1/2″ ID

Steel swivel for shock mounts. Comes with spacers and nut.

Each Kit includes (2) parts. Kit consists of;  (1) upper and (1) lower 1/2" - 20 stainless steel shock nut with double tapped through hole for 8/32" and 10/32" shock sensor eyelets.  Works on both 1/2" diameter shock sensors and 1" diameter...

Our standard slider cups now capture the OD of the spring to keep it more linear through travel. This is the removable side cup.

Rebuild kit for our spring sliders. Includes new style bushing, piston, snap ring, o-ring, and nyloc nut.

This spring alignment plate works with soft rate springs using the 5" OD to align the spring instead of the ID on our coil over spring sliders and our WM285D drop bearing RF spring cup.  You can also run WM165BO on one end of...