Rear Suspension

This spring alignment plate works with soft rate springs using the 5" OD to align the spring instead of the ID on our coil over spring sliders and our WM285D drop bearing RF spring cup.  You can also run WM165BO on one end of...

Just like our aluminum one, only made out of steel dom tubing, has two inches of adjustment like the aluminum one - just a little heavier. This bar is our body #1 with a WM40A and is 18''-20''.

Steel chain holder with bearing. This keeps the chain bind free through the range of motion

Our new Brad Waits designed quick change limit chain adjuster allows you to change your chain length by simply pulling a pin, moving to the next hole and inserting the pin. You can make a chain adjustment in seconds with no tools. Made of steel with no...

STEEL SWEDGED RADIUS RODS. 5/8-18 FEMALE THREADS, 7/8 O.D. BLACK

STEEL RADIUS RODS - 3/4-16 FEMALE THREADS, 1" O.D. BLACK

Steel weld-in tube ends. Available in 1/2-20 (1" .083wall tubing) 5/8-18 and 3/4-16 (1.25 .083 wall tubing)

Steel clamp on 3/4'' heim mount 1-1/2'' round tube 5/8'' bolt.

1/2"-20 thread 20" long strut tube to support lift bar.Comes with LH and RH 1/2" heim.

Our NEW swivel shock mount has a swivel clevis bolted to an 8" long 1" threaded screw jack bolt. The swivel allows adjustability when mounting your shock. Make sure to secure the swivel using thread lock on the bolt.

Adjustments made easy! Grab your 1-1/4" wrench and turn the tube clamp to adjust your suspension tubes. Designed for use with our WM450 Suspension Tube Jam Nuts.Sold seperately is our WM450W Stubby 1-1/4" wrench.

Our all-new Threaded Double Adjustable Limiter will make length adjustment easy and fast with our LH and RH adjust to allow for quick fine tuning of you suspension limiter.  This takes our 2" diameter 1" tall foam pucks that come in 4 durometers...